Engine Removal ??????

azygoustoyou · Post by **azygoustoyou** » Thu Jan 28, 2010 5:37 pm

How the H#ll do you remove the engine from these cars??????

I got tired of trying to figure it out so I cut the front end off

By the way, do you like the single hump?

halg · Post by **halg** » Fri Jan 29, 2010 12:07 am

What you cut off will not help. Make a cut 90deg from what you did, the whole length of the car and the engine will be sitting on the ground.
Hal

So Cal Mark · Post by **So Cal Mark** » Fri Jan 29, 2010 12:09 am

or you could wait for the crossmember to rust away from the body, then lift the car off the motor

ITA124 · Post by **ITA124** » Fri Jan 29, 2010 4:59 am

Man. You guys in the States are way too spoilt.

Here in Aus, the value of the chassis would far outweigh that of the engine.

azygoustoyou · Post by **azygoustoyou** » Fri Jan 29, 2010 11:22 am

NO, just playing around. This car is a rust bucket and the frame on the drivers side is gone. I'm not wasting it though.

rlux4 · Post by **rlux4** » Sat Jan 30, 2010 10:11 pm

Brady, you bad. Veddy, veddy bad man.
Ron