Workin' under hood

mostlytwowheeled · Post by **mostlytwowheeled** » Sat Mar 12, 2011 10:56 am

Well the sun broke out yesterday and temp was in the 40's. So I took off the tarp covering "Tony" and put on a new fuel pump. Next will be the intake manifold and carb. But before I get to that I need the small molded ruber tube from the block to the vapor/oil seperator casting. Anyone know where I can find one? I checked the IAP catalogue, but couldn't find one there. Thanks

So Cal Mark · Post by **So Cal Mark** » Sat Mar 12, 2011 10:57 am

there are two different hoses, depending what year engine you have

mostlytwowheeled · Post by **mostlytwowheeled** » Sat Mar 12, 2011 10:59 am

Hi Mark, That engine would be a 79' 2 liter. Might you have one?

mostlytwowheeled · Post by **mostlytwowheeled** » Sat Mar 12, 2011 12:46 pm

Found one. It's on it's way.

jaownbey · Post by **jaownbey** » Mon Apr 04, 2011 12:25 am

mostlytwowheeled wrote:Well the sun broke out yesterday and temp was in the 40's. So I took off the tarp covering "Tony"

40's?! You need to move south my man...

Workin' under hood

Workin' under hood

Re: Workin' under hood

Re: Workin' under hood

Re: Workin' under hood

Re: Workin' under hood