Brakes Pulling

Suspension related stuff goes in here.
Post Reply
tonym
Patron 2020
Patron 2020
Posts: 28
Joined: Sat Jun 24, 2017 11:22 pm
Your car is a: 1979 spider 124

Brakes Pulling

Post by tonym »

Struggled with a leftward pull on braking and almost all brake related solutions pointed to right brake caliper. After pulling piston, cleaning everything and lubing seals with fluid and greasing stops, still had the problem. Noticed that the driver's side wheel was a little harder to spin so I pulled that caliper off and did the aforementioned conditioning to it and, lo and behold, problem solved. So it's not always the opposite caliper that be the culprit.
18Fiatsandcounting
Posts: 3798
Joined: Fri Mar 15, 2019 11:23 pm
Your car is a: 1969 and 1971 124 spiders
Location: San Francisco Bay Area

Re: Brakes Pulling

Post by 18Fiatsandcounting »

Glad you found the problem, and I'll just add that sometimes pulling to one side is caused by alignment, front suspension, or tire issues, rather than the brake calipers themselves.

-Bryan
tonym
Patron 2020
Patron 2020
Posts: 28
Joined: Sat Jun 24, 2017 11:22 pm
Your car is a: 1979 spider 124

Re: Brakes Pulling

Post by tonym »

Yes, neglected to say I checked all of those as well. Ran straight with toe in, caster and camber in spec, suspension was tight and tires are new, balanced and equal pressure. Calipers are original with new seals so not sure why they got sticky after a year of flawless performance. May need to eventually replace them but I'd like to keep stock parts as much as possible.
18Fiatsandcounting
Posts: 3798
Joined: Fri Mar 15, 2019 11:23 pm
Your car is a: 1969 and 1971 124 spiders
Location: San Francisco Bay Area

Re: Brakes Pulling

Post by 18Fiatsandcounting »

Fiats don't like to be ignored. Drive them daily, or you will be on the receiving end of wrath. I could make a comparison here, but I'll stop now before I get into trouble.

-Bryan
DieselSpider
Posts: 2130
Joined: Wed Dec 24, 2014 10:21 pm
Your car is a: 1978 124 Spider with Isuzu Turbo Diesel

Re: Brakes Pulling

Post by DieselSpider »

When you do the brake fluid flush every 2 years regardless of the miles driven the caliper guides, wedges, etc need to be cleaned and lubricated with a good quality high temperature caliper grease. This is more critical on seldom driven cars since once this grease gets thin and starts to dry out they will start to bind and braking will be uneven. If this is allowed to slide you really need to do a thorough job of cleaning up the caliper guides, wedges, etc before applying the caliper grease to all the points that slide. Leave a little rust/corrosion behind or fail to apply an adequate amount of grease and you may have issues in very short time.

Also note that caliper service should always be done on the pair for that axle and not ever on just one side.
tonym
Patron 2020
Patron 2020
Posts: 28
Joined: Sat Jun 24, 2017 11:22 pm
Your car is a: 1979 spider 124

Re: Brakes Pulling

Post by tonym »

Thanks guys. They're greased up good now. And good call on the no comment Bryan. :)
18Fiatsandcounting
Posts: 3798
Joined: Fri Mar 15, 2019 11:23 pm
Your car is a: 1969 and 1971 124 spiders
Location: San Francisco Bay Area

Re: Brakes Pulling

Post by 18Fiatsandcounting »

tonym wrote:And good call on the no comment Bryan. :)
Heh, heh, heh...!! :wink:

-Bryan
Post Reply