Page 1 of 1
So what do I need, and where do I get it?
Posted: Mon Mar 09, 2015 2:25 am
by VanillaThunder
Here's what I need to fix. I've seen the whole Pinnn badge, including the crown, gasket, etc.. But I don't know what I need to complete what's already there, just the Pinn badge, no crown, no surround. Is this possible/available? I've looked everywhere.
Would appreciate input.
Re: So what do I need, and where do I get it?
Posted: Mon Mar 09, 2015 5:47 am
by RRoller123
I haven't seen just the graphic for sale anywhere myself.
Re: So what do I need, and where do I get it?
Posted: Mon Mar 09, 2015 8:47 am
by 124JOE
just get a new badge
have you looked at international auto parts?
or autoricrombi, and other supplyers?
Re: So what do I need, and where do I get it?
Posted: Mon Mar 09, 2015 10:29 pm
by So Cal Mark
that original badge had a plastic insert that faded in about one year. I offer a zinc plated badge with hard enamel that will not fade for $20 each.
http://cgi.ebay.com/ws/eBayISAPI.dll?Vi ... RK:MESE:IT
Re: So what do I need, and where do I get it?
Posted: Tue Mar 17, 2015 8:56 pm
by 80spiddy
My 80 spider had none. I bought a couple from Mark. Nice pieces. But, the badge must need the rubber backing to fit the body holes I assume. Otherwise the badge sticks out from the body. Am I correct?
Re: So what do I need, and where do I get it?
Posted: Tue Mar 24, 2015 4:04 pm
by 124JOE
the holders are plastic
Re: So what do I need, and where do I get it?
Posted: Tue Mar 24, 2015 9:50 pm
by DieselSpider
I went with this full kit that has the enameled metal badges, gaskets and retainers:
http://www.vickauto.com/newstore/index. ... ts_id=3800
The online pictures do not do them justice.