Recommended Tools, Spare Parts, Books?

[Snoopy]

If you REALLY want to get into the weeds, this link takes you to the Bosch L-Jetronic manual which goes much further than you probably ever want to go!

http://bama.ua.edu/~darren/boschindex.html

[wachuko]

If you REALLY want to get into the weeds, this link takes you to the Bosch L-Jetronic manual which goes much further than you probably ever want to go!

http://bama.ua.edu/~darren/boschindex.html

Another site with the same pdf is listed in my first post: http://foxed.ca/rx7manual/manuals/BOSCH ... Manual.pdf

I will add that second site as well.

[wachuko]

Added a MIG welder to the list and the great site recommended by Michael (seabeelt) - http://www.mig-welding.co.uk/mig.htm

[azruss]

only thing not discussed is a tool for removal and install of e-brake wedge in the rear caliper. I built my own. many have developed technique to not require anything special. never got those to work.
also, a roll of coins for holding a stretched clutch pedal spring.
a low-pro floor jack and jack stands.
I build myself a set of 12" drive up ramps. use them all the time. faster and safer than a jack and jack stands.
if your dizzy is up top, a custom dizzy wrench. I took an open end wrench the bent it into an ell.
a first class set of snap-ring (circlip) pliers
thread gage
impact driver with phillips bits
1/2" breakerbar and 3/4" pipe extention. (great for loosening crank bolt).

after all this, you will be too tired out to work on your car!

[wachuko]

Head stands...

[wachuko]

only thing not discussed is a tool for removal and install of e-brake wedge in the rear caliper. I built my own. many have developed technique to not require anything special. never got those to work.
also, a roll of coins for holding a stretched clutch pedal spring.
a low-pro floor jack and jack stands.
I build myself a set of 12" drive up ramps. use them all the time. faster and safer than a jack and jack stands.
if your dizzy is up top, a custom dizzy wrench. I took an open end wrench the bent it into an ell.
a first class set of snap-ring (circlip) pliers
thread gage
impact driver with phillips bits
1/2" breakerbar and 3/4" pipe extention. (great for loosening crank bolt).

after all this, you will be too tired out to work on your car!

Cool. I will update the list.

[wachuko]

If you have seen this before, then disregard.
This little tool works too well to not have it in your box.

the rear calipers need to turn in to fit new pads
this tool works faster than others

One more for the tool box. Thank you Roy!