New/Old Member from Denver

E Prod Racer · Post by **E Prod Racer** » Mon Feb 05, 2007 12:48 am

I just started posting again here after about a two year absence. I have a Fiat racecar (hence the handle) that you can check out at Fire Breathing Fiats: http://www.firebreathingfiats.com/Contr ... cMahan.htm

I also once owned and built Don Tuscany's racer which is also on the same site - thanks for hosting, Joe!

My other FIAT is a 124 Abarth Stradale replica I am building, which I hope to have fully finished for this year's driving season. You can check the progress on the build on my business site at: http://www.macautosport.com/index.php?o ... itemId=231

I own a dyno tuning speed shop in Denver - MAC Autosport. We modify and tune performance cars. We work on racecars, street performance cars, import performance cars, vintage racers, and classic muscle cars. I have owned and raced FIATs for more than 25 years. If you need some experienced help with your Spider, you can always drop me a PM, or post here on the forum. This forum helps me, and I would like to return the favor.

mdrburchette · Post by **mdrburchette** » Mon Feb 05, 2007 5:47 am

Welcome back Bill. I enjoyed reading the story on your racing career. Good luck this year!

Gerard Del Monte · Post by **Gerard Del Monte** » Mon Feb 05, 2007 12:21 pm

Welcome back Bill. If you ever again make those Stradale louvered hood replacements, make sure you post their availability please!

E Prod Racer · Post by **E Prod Racer** » Tue Feb 06, 2007 12:30 am

I have to rebuild the racer for this year and I'm behind in the work. Have to replace the rollcage - SCCA no longer will pass my cage's main hoop. Also building a 1756 engine to move the car to FProduction, so I have a lot to do. Hope to have the car ready by April.

I have the molds to make Fiberglass hoods with the small bumps, and can cut in the corner vents, but I am looking for someone to take the molds and make the parts for me - I don't have the time to lay them up, or finish them off. I don't have any extras right now. I also have the molds to make rear decks, too - with an extra inner mold for the latch. If anyone has the time and skill to use these molds, please contact me.