Vacuum LIne

[davery]

I have a FI spider and it looks like I have an unattached vacuum line. The starts at the vacuum advance module and travels along the firewall. I'm not sure where the other ends should be attached. Any ideas?

[So Cal Mark]

there is a vacuum nipple below the throttle plate on the intake plenum

[edcreed]

Sorry to hijack this thread, but I have the same issue. Does anyone happen to have a good pic of that nipple? I've looked for an hour and can't find it. ..thanks

[DRUMMOND]

[micbrody]

That is not the nipple for vacuum advance . (Previous picture) . That , instead is vacuum hose that goes to top of charcoal canister

[micbrody]

I don't have photo, but feel under the big black hose (cyclonic oil/vapor separator hose)that attaches to throttle plate just near where end of throttle cable is attached to engine

[RRoller123]

Yep, it is just about under the big coiled throttle return spring, on the throttle body. Small diameter, points horizontally straight out towards the rear.

[DRUMMOND]

Sorry wrong photo. Here it is

[edcreed]

awesome, I found it...but I had some other hose hooked up there...so I've switched them, but now need to find where this new hose goes. The other end is attached to a small white rectangular box that's mounted on the driver side wall of the engine bay.

here are two different pics of the little white box...can anyone tell me what this thing is below the yellow circled item? (ignore the yellow circle, that was for another post.. )


and here in the top right corner of the pic


thanks again
Ed

[edcreed]

Okay so it turns out the little white box pumps water for the windshield wiper spray. ..problem solved

Thanks
Ed