My car will idle and and over heat within 3 minutes. The idiot gauge starts to swing over into the RED I can put my finger into the radiator and the water is cold. Is this a tale, tale sign of a plugged up radiator?
I did install a new thermostat when I put the engine back into the car.
Rodman
Heat problem
- azruss
- Posts: 3659
- Joined: Sun May 30, 2010 12:24 pm
- Your car is a: 80 Fiat 2000 FI
Re: Heat problem
You are getting no circulation. Can't remember if you have an exterior thermostadt. could be a bad water pump. If it cooled fine before then it is a thermostadt issue. Either it is stuck or installed wrong. If you think the radiator is clogged. loosen the cap and open the petcock on the bottom. If it just dribbles out, you probably have a radiator issue.
Re: Heat problem
azruss wrote:You are getting no circulation. Can't remember if you have an exterior thermostadt. could be a bad water pump. If it cooled fine before then it is a thermostadt issue. Either it is stuck or installed wrong. If you think the radiator is clogged. loosen the cap and open the petcock on the bottom. If it just dribbles out, you probably have a radiator issue.
I installed a internal thermostat. The bottom or the top radiator is cold. Not sure about before cause brought the car home and tore it all apart the next day....
-
- Posts: 1359
- Joined: Wed Nov 02, 2011 11:11 am
- Your car is a: 1971 124 Spider 1608
Re: Heat problem
Could it be air trapped in the system. Did you install a t at the high point.(heater hose?). This is a cheap, easy thing to install and it really makes burping the system a breeze.
Re: Heat problem
Did you bleed the system correctly? Meaning got read of the bubbles.
If not, could it be that you put the thermostat backward?
Just giving ideas
If not, could it be that you put the thermostat backward?
Just giving ideas
- SLOSpider
- Posts: 1140
- Joined: Wed Mar 03, 2010 2:10 am
- Your car is a: 1973 124 Spider 2.0FI
- Location: Lompoc, Ca USA
Re: Heat problem
A small hole drilled in the thermostat when mounted in the head helps a ton to remove trapped air. Some come with this already. Sounds like you got an air pocket in there.
1975 124 Spider
1976 Mazda Cosmo http://www.mazdacosmo.com
1989 Chevy k5 Blazer
1967 GT Mustang Fastback
1976 Mazda Cosmo http://www.mazdacosmo.com
1989 Chevy k5 Blazer
1967 GT Mustang Fastback
Re: Heat problem
Removed the thermostat today was installed correctly. So I left it out and let it run it did not heat up. So maybe bad thermostat ( even though it was new ).
Untitled by fiatcs2000, on Flickr
Untitled by fiatcs2000, on Flickr
- azruss
- Posts: 3659
- Joined: Sun May 30, 2010 12:24 pm
- Your car is a: 80 Fiat 2000 FI
Re: Heat problem
It could be a pocket of air under the thermostadt. Do a bench test on the thermostadt. Take a cup of water and heat it to boiling in the microwave. put the thermostadt in the cup. it should open full wide. As the cup cools you should be able to watch it close.
- SLOSpider
- Posts: 1140
- Joined: Wed Mar 03, 2010 2:10 am
- Your car is a: 1973 124 Spider 2.0FI
- Location: Lompoc, Ca USA
Re: Heat problem
Drill a small bleed hole in it when you reinstall.
1975 124 Spider
1976 Mazda Cosmo http://www.mazdacosmo.com
1989 Chevy k5 Blazer
1967 GT Mustang Fastback
1976 Mazda Cosmo http://www.mazdacosmo.com
1989 Chevy k5 Blazer
1967 GT Mustang Fastback
Re: Heat problem
Could be "air locked" too. An air bubble trapped in the head . . since the head is above the radiator. Had lots of trouble with this when I first bought my car.