Por-15

akavinn1 · Post by **akavinn1** » Tue Jul 26, 2011 10:01 pm

I want to por-15 the undercarriage of my 76 but I am not sure how much I will need and if I need to buy the prep stuff ?

azruss · Post by **azruss** » Wed Jul 27, 2011 2:01 am

there are many fans of por-15. I'm not one of them. the car i'm resto'ing now has many por'd parts and i removed it because of separation and water getting underneath and rusting the metal. It is a paint and requires the same level of prep to get it to stick and stay.

seabeelt · Post by **seabeelt** » Wed Jul 27, 2011 7:19 am

Eastwood IMO has a better product with so called proven test results between the two. Check their website. Eastwood.com and do the search on POR. An no I don't work there

engineerted · Post by **engineerted** » Wed Jul 27, 2011 9:03 am

Two votes no! I am not a fan either, A good epoxy paint or bed liner is a better choice.

Ted

akavinn1 · Post by **akavinn1** » Wed Jul 27, 2011 10:32 am

Thanks for the advice ! I am trying to protect it from rust the best that I can and give it a clean look too

azygoustoyou · Post by **azygoustoyou** » Wed Jul 27, 2011 11:23 am

I vote no for Por15 too.

akavinn1 · Post by **akavinn1** » Wed Jul 27, 2011 12:44 pm

so any suggestions Brady ?

azygoustoyou · Post by **azygoustoyou** » Wed Jul 27, 2011 7:50 pm

If you were to strip the bottom, I would use Master Series for a sealer then a quality bed liner like Ted suggested. Epoxy paint is great too. I used it on my car.
Check everywhere to see if all undercoating is attached. I found in several places where it was loose and easily pulled off.
That was one reason I stripped the bottom. I also found rust in between the undercoating and body that was hard to remove. This is a hard task to do just by jacking the car up. It took me a week just to clean mine on a Rotisserie.
Eastwood makes a material that is sprayed on the undercoating to easily remove it.

Por-15

Por-15

Re: Por-15

Re: Por-15

Re: Por-15

Re: Por-15

Re: Por-15

Re: Por-15

Re: Por-15